RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-107
RDFCOM Messages
error#
is a file-system error number that indicates lack of storage space on disk.
Cause. During execution of a START RDF command, RDFCOM determined that
sufficient disk storage for image files did not exist.
As one of its validation checks during START RDF processing, RDFCOM tries to
create a temporary image file on the receiver’s RDFVOLUME and then to allocate all
16 extents. This check, if successful, verifies that:
•
If RDF is starting for the first time, there is enough storage for at least one image
file
•
If RDF has been started previously, there is enough storage for one image file
when the next image-file rollover occurs
If the check fails because there is insufficient storage, this message appears.
Effect. The START RDF command is aborted.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Make sufficient space available on
disk, and then reenter the START RDF command.
error#
is the file-system error number that identifies the specific error.
Cause. During execution of a START RDF command or a VALIDATE
CONFIGURATION command, RDFCOM determined that sufficient disk storage for
image files did not exist on the RDFVOLUME. As one of its validation checks during
processing of these commands, RDFCOM tries to create a temporary image file on the
receiver’s RDFVOLUME and then to allocate all 16 extents. This check, if successful,
verifies that:
•
If RDF is starting for the first time, there is enough storage for at least one image
file
•
If RDF has been started previously, there is enough storage for one image file
when the next image-file rollover occurs
If the check fails because there is insufficient storage, this message appears.
Effect. The command fails.
RECEIVER RDFVOL error error# on allocation
RECEIVER RDFVOL error error# on creation