RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-108
RDFCOM Messages
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system
manager.
volume-name
is the name of the non-existent RDFVOLUME file.
Cause. The RDF configuration file is invalid.
Effect. The validation of the receiver fails.
Recovery. Specify a valid disk volume.
Cause. You tried to add a secondary image trail before adding the receiver’s
configuration record.
Effect. The command fails.
Recovery. Add the receiver’s record. Then, add the secondary image trail.
Cause. An ADD RECEIVER command was issued when the configuration file already
contained a receiver record.
Effect. The command fails.
Recovery. No recovery is required if you want to use the existing receiver process as
it is configured. If you want to change any of the receiver’s configuration options,
however, enter an ALTER RECEIVER command that specifies those changes.
Cause. The INFO command could not find a receiver record in the configuration file.
Effect. The command fails.
Recovery. Alter the configuration to include a receiver process.
RECEIVER RDFVOLUME volume-name does NOT exist
RECEIVER Record does not exist
RECEIVER record exists, use ALTER RECEIVER
RECEIVER record NOT found.
Receiver record not found for subsystem ctrl-subvol.