RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-113
RDFCOM Messages
If the shutdown record is located in an audit file that is no longer on disk, you will need
to restore that file to disk, as well as all files between it and the latest file, and then
reenter the command. For example, if files AA000009 through AA000010 are currently
on disk, and the shutdown record is located in AA000007, then you must restore
AA000007 through AA000008 to disk. Alternatively, you can use a different TMF
shutdown point that is located in a MAT file still on disk, or you can stop TMF and use
that resulting shutdown point.
Cause. A START RDF command aborted.
Effect. The command fails.
Recovery. Scan the EMS event log to determine why the command aborted, correct
the error if possible, and reenter the START RDF command.
Cause. A START UPDATE command is being executed.
Effect. The start operation continues for the updater process.
Recovery. This is an informational message; no recovery is required.
Cause. A START RDF command is being executed.
Effect. The start operation continues for RDF.
Recovery. This is an informational message; no recovery is required.
primary
is the name of the primary node in the RDF configuration.
backup
is the name of the backup node in the RDF configuration.
Cause. A STATUS RDF command was issued while RDF was not running.
Effect. The command fails.
START RDF Aborted
START UPDATE in progress, Please Wait...
Starting RDF, Please Wait...
STATUS RDF (\primary-> \backup) is NOT running