RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-115
RDFCOM Messages
Cause. You entered a STOP UPDATE command, but the monitor could not send stop
messages to all updater processes and has logged RDF error 841 to the EMS event
log.
Effect. Some updaters might have shut down, but others never received the stop
message and are still running. The receiver and monitor cannot now identify these
updaters, and you cannot stop them with another STOP UPDATE command or a
STOP RDF command.
Recovery. All remaining updaters must be manually stopped from the TACL interface
(for example, with a TACL STOP $UPD1 command). Examine the EMS event log for
the error message 841; this message contains the Guardian error number that the
monitor received when attempting to stop the updater.
Cause. The COPYAUDIT command has located the missing audit for the image trail
identified in the previous message and is ready to move that audit from the remote
system to the local system.
Effect. The COPYAUDIT command moves the audit to the local system.
Recovery. This is an informational message; no recovery is required.
Cause. You specified an incorrect value for the SUFFIX option of the INITIALIZE RDF
command.
Effect. The INITIALIZE RDF command is aborted.
Recovery. Reenter the command, specifying a single alphanumeric character for the
suffix character.
error#
is the file-system error number that identifies the specific error.
Cause. A NEWPROCESS error occurred during START RDF or TAKEOVER
processing.
Effect. The command fails.
STOP UPDATE request could not be completed
Storing missing audit in the imagetrail.
SUFFIX must be a single alphaumeric character
Swap File Error: error#