RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-116
RDFCOM Messages
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting process errors, see the
Guardian Procedure Errors and Messages Manual. If possible, correct the error and
reenter the command that encountered the error. Otherwise, see your system
manager.
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an
RDFCOM INITIALIZE RDF command.
Cause. In conjunction with a complete database synchronization, a record whose
timestamp is less than synchdbtime has been located successfully.
Effect. The RDFCOM INITIALIZE RDF command continues.
Recovery. This is an informational message; no recovery is required.
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an
RDFCOM INITIALIZE RDF command.
Cause. In conjunction with a complete database synchronization, you are attempting
to initialize RDF to a timestamp that is earlier than the current time. A record whose
timestamp is less than synchdbtime has been found, and synchdbtime has been stored
in the RDF configuration record.
Effect. The RDFCOM INITIALIZE RDF command continues.
Recovery. This is an informational message; no recovery is required.
Cause. A takeover operation is underway.
Effect. The takeover operation continues.
Recovery. This is an informational message; no recovery is required.
Synch point for synchdbtime has been found
Synch timestamp is synchdbtime
TAKEOVER in progress