RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-120
RDFCOM Messages
Cause. You must specify a process name for the RDFNET process before issuing an
ADD command.
Effect. The start command fails.
Recovery. You must reconfigure RDF with a named RDFNET process.
name
is the name of the remote RDF control subvolume.
bksys
is the backup system name.
Cause. You tried to execute an INITIALIZE RDF command, but the RDF control files
(such as CONFIG or CONTEXT) already exist on the remote control subvolume. If
these files are on the backup system, then that name is specified.
Effect. The INITIALIZE RDF command aborts.
Recovery. You must purge \system.name.* on the backup systems before you can
retry the INITIALIZE RDF command. Before doing so, however, be sure that the
existing files do not belong to a different RDF configuration that is still valid.
Cause. You have specified an INITTIME timestamp that is in the future rather than in
the past.
Effect. The INITIALIZE RDF command aborts.
Recovery. Reissue the STOP UPDATE, TIMESTAMP command, specifying a
timestamp that is earlier than the current system time as shown in the status display.
Cause. The timestamp specified in a STOP UPDATE, TIMESTAMP command is less
than five minutes from the current time.
Effect. The STOP UPDATE command aborts.
Recovery. Reissue the STOP UPDATE, TIMESTAMP command, specifying a
timestamp that is at least five minutes ahead of the current time.
The [remote] control subvolume name [on bksys] is not empty.
The files on the control subvolume must be purged. Please
note, these files may belong to another RDF configuration.
The specified timestamp cannot be in the future
The specified timestamp must be at least five minutes greater
than the current time