RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-123
RDFCOM Messages
Cause. TMF has not been started.
Effect. The requested RDFCOM operation fails.
Recovery. Check the contents of the RDF configuration file, issue a VALIDATE RDF
command to verify the configuration, and reissue your request for the RDFCOM
operation you originally wanted to perform.
Cause. There is a problem with TMF.
Effect. The configuration validation fails.
Recovery. Check the status of TMF. When TMF is operational, reenter the command.
timestamp
is the shutdown timestamp sought.
filename
is the name of the MAT file that contained the record with the matching timestamp.
relative-byte-address
is the relative byte address where the record with the matching timestamp was
found in the MAT file.
Cause. RDFCOM has found the TMF shutdown timestamp identical to the timestamp
specified in the INITIALIZE RDF timestamp command.
Effect. RDF is ready to be initialized at the specified timestamp.
Recovery. This is an informational message; no recovery is required.
Cause. A TMF stop operation is in progress.
Effect. TMF stops, and RDF automatically stops thereafter.
Recovery. This is an informational message; no recovery is required.
TMF is not started yet.
TMF NAT table is full.
TMF Shutdown at timestamp has been found.
RDF starts with MAT file filename
at RBA relative-byte-address
TMF STOP in progress.