RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-126
RDFCOM Messages
Effect. The ADD command fails.
Recovery. Exit RDFCOM and then try again. If the problem persists, contact the
Global Customer Support Center (GCSC) or your service provider.
error#
is the file-system error number that identifies the specific error.
Cause. A START RDF command failed because the reported error prevented
RDFCOM from purging the old image file.
Effect. The command fails.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Manually purge any files on the
image file subvolume, and then reissue the START RDF command.
error#
is the file-system error number that identifies the specific error.
Cause. A DELETE IMAGETRAIL command tried to delete an image trail, but
RDFCOM could not purge all image files in the trail because of the error denoted by
file-system file-error.
Effect. The command fails.
Recovery. Refer to the Operator Messages Manual for a description of the error code.
For additional details about understanding and correcting file-system errors, see the
Guardian Procedure Errors and Messages Manual. Correct the error and reenter the
command.
Unable to purge old image file due to error error#
DELETE ABORTED
Unable to purge remaining image files; error error#