RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-128
RDFCOM Messages
Cause. A START UPDATE command was issued when updating is enabled.
Effect. The command fails.
Recovery. This is an informational message; no recovery is required.
Cause. RDFCOM could not execute a START UPDATE or STOP UPDATE command.
Effect. The command fails.
Recovery. Scan the EMS event log to determine why the command could not be
performed. Correct the error condition, if possible, and request the update operation
again.
device
is the non-disk device assigned to the updater.
Cause. The RDF configuration file is invalid.
Effect. RDF will not start.
Recovery. Change the RDF configuration to reflect a valid disk volume.
device
is the non-disk device assigned for the UPDATEVOLUME.
Cause. The RDF configuration file is invalid.
Effect. RDF will not start.
Recovery. Change the RDF configuration to reflect a valid disk volume.
UPDATE is already on
UPDATE request could not be performed
VOLUME device is NOT a disk volume
VOLUME device UPDATEVOLUME is NOT a disk volume