RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-129
RDFCOM Messages
Cause. An ADD VOLUME command was issued when the configuration file already
contained an updater record for the volume.
Effect. The RDF command fails.
Recovery. No recovery is required if you want to use the existing updater process as it
is configured. If you want to change any of the updater’s configuration options,
however, enter an ALTER VOLUME command that specifies those changes.
volume
is the offending SMF virtual disk
Cause. The updater is configured to a virtual SMF disk that consists of more than 15
physical disks. This configuration is not supported by the RDF product.
Effect. RDF will not start.
Recovery. Reset your RDF configurations and/or your SMF configuration so that the
updaters are either assigned to physical volumes, or your SMF virtual disks map to 15
or fewer physical volumes.
volume
is the volume on the primary node for which the updater is responsible.
Cause. The RDF configuration file is invalid.
Effect. RDF will not start.
Recovery. Bring the volume up or delete it from the RDF configuration.
volume
is the volume on the primary node for which the updater is responsible.
Cause. The RDF configuration file is invalid.
Effect. RDF will not start.
VOLUME Record exists, use ALTER VOLUME volume
VOLUME volume contains too many physical volumes
The SMF pool cannot contain more than 15 volumes
VOLUME volume does NOT exist
VOLUME volume is NOT configured within TMF