RDF/IMP and IMPX System Management Manual (RDF 1.4+)

Messages
HP NonStop RDF/IMP and IMPX System Management Manual—524388-001
C-131
RDFCOM Messages
Cause. You added an updater with the specified ATINDEX, but the IMAGEVOLUME
configured for the updater does not have that value.
Effect. The validation fails.
Recovery. Alter the particular updater’s ATINDEX value to match the appropriate audit
trail number or delete the updater.
Cause. You added an updater with the specified ATINDEX, but the primary system
data volume to be protected is not mapped to the audit trail with that audit trail number.
Effect. The validation fails.
Recovery. Alter the particular updater’s ATINDEX value to match the appropriate audit
trail number or delete the updater.
Cause. The user attempted to SET or ALTER the RDF BACKUPSWAP parameter.
Effect. This parameter no longer has any effect. The KMSF subsystem controls the
placement of the RDF processes’ swap files.
Recovery. This is an informational message; no recovery is required.
procname
is the RDF process without a backup CPU, which is one of the following:
EXTRACTOR, MONITOR, RECEIVER, or $volume UPDATER.
Cause. RDF is started without a backup process for the process identified in this
message.
Effect. RDF is started.
Recovery. Stop RDF, reconfigure it to include a backup CPU for the RDF process, and
start the subsystem once again.
VOLUME vol-name does not match imagetrail ATINDEX atindex
VOLUME vol-name is NOT audited to ATINDEX atindex
WARNING - BACKUPSWAP parameter has no effect, KMSF swap
volume takes precedence
WARNING: No backup cpu has been configured for the procname