RDF/IMP, IMPX, and ZLT System Management Manual

Entering RDFCOM Commands
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
8-36
Command Overview
RDF displays the following:
VOLUME $DATA01
VOLUME ATINDEX 0
VOLUME CPUS 0:1
VOLUME IMAGEVOLUME $SECIT1
VOLUME PRIORITY 170
VOLUME PROCESS $UP1
VOLUME UPDATEVOLUME $DATA1
Now, suppose you configured three updater processes (named $UP01, $UP02, and
$UP03) and that those processes are backing up the primary system volumes
$DATA01, $DATA02, and $DATA03, respectively, onto the volumes $DATA1,
$DATA2, and $DATA3 on the backup system. The updaters $UP01 and $UP02 are
accessing the secondary image trail $SECIT1; updater $UP03 is accessing the
secondary image trail $SECIT2.
To display the current configuration parameters for all of the updater processes, enter:
]INFO VOLUME *
RDF displays the following:
VOLUME $DATA01
VOLUME ATINDEX 0
VOLUME CPUS 0:1
VOLUME IMAGEVOLUME $SECIT1
VOLUME PRIORITY 160
VOLUME PROCESS $UP01
VOLUME UPDATEVOLUME $DATA1
VOLUME $DATA02
VOLUME ATINDEX 0
VOLUME CPUS 2:3
VOLUME IMAGEVOLUME $SECIT1
VOLUME PRIORITY 160
VOLUME PROCESS $UP02
VOLUME UPDATEVOLUME $DATA2
VOLUME $DATA03
VOLUME ATINDEX 0
VOLUME CPUS 4:5
VOLUME IMAGEVOLUME $SECIT2
VOLUME PRIORITY 160
VOLUME PROCESS $UP03
VOLUME UPDATEVOLUME $DATA3