RDF/IMP, IMPX, and ZLT System Management Manual

Entering RDFCOM Commands
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
8-52
Command Overview
NETWORK
resets the values for the network configuration record.
For all of the default parameter values for the RDF global options and the individual
processes see the SET EXTRACTOR, SET IMAGETRAIL, SET MONITOR, SET
PURGER, SET RDF, SET RDFNET, SET REDFNETWORK, SET RECEIVER, and
SET VOLUME command descriptions.
Where Issued
Primary system only.
Security Restrictions
You can issue the RESET command only if you are a member of the super-user group.
RDF State Requirement
You can enter the RESET command at any time, whether or not RDF has been
started. Certain constraints, however, apply to the subsequent ADD commands that
apply the RESET values to the configuration file. For further information, see the ADD
command description.
Usage Guidelines
The RESET command operates on the values in the configuration table in memory
(which serves as a buffer), resetting those for the specified process to their default
settings. These values do not affect RDF, however, until they are applied to the RDF
configuration file with the ADD command.
Examples
To reset the extractor process parameters in the configuration memory table to their
default values, enter:
]RESET EXTRACTOR
To reset the extractor process parameters in the configuration file to their default
values so that these values now affect RDF, issue the following commands after RDF
has been initialized:
]RESET EXTRACTOR
]SET EXTRACTOR PROCESS $EXT
]ADD EXTRACTOR
To reset the updater process parameters is in the configuration memory table to their
default values, enter:
]RESET VOLUME