RDF/IMP, IMPX, and ZLT System Management Manual

Entering RDFCOM Commands
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
8-68
Command Overview
RDF State Requirement
You can only enter the SET RDF command for global configuration parameters if you
have not already used the ADD RDF command to apply the parameter values to the
RDF configuration file. For further information, see the ADD command description.
Usage Guidelines
The SET RDF command enters the global parameter values specified in this command
into the RDF configuration table in memory. This table serves as an input buffer only,
and so these values do not affect the subsystem until they are applied to the RDF
configuration file with the ADD command.