RDF/IMP, IMPX, and ZLT System Management Manual

Entering RDFCOM Commands
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
8-74
Command Overview
By default, in this example the receiver process is associated with the MAT and will run
at a priority of 165.
To configure an auxiliary receiver process named $RCV1 associated with the auxiliary
audit trail AUX01 to run in CPUs 2 and 3, issue the following commands:
]SET RECEIVER PROCESS $RCV1
]SET RECEIVER ATINDEX 1
]SET RECEIVER CPUS 2:3
]ADD RECEIVER
By default, in this example the auxiliary receiver process will run at a priority of 165.