RDF/IMP, IMPX, and ZLT System Management Manual

Entering RDFCOM Commands
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
8-102
Command Overview
4. Having initiated the RDF TAKEOVER operation, you can then use a STATUS RDF
command to determine the status of the TAKEOVER operation. If the TAKEOVER
operation is still in progress when you enter the STATUS RDF command, the
subsystem displays the current state as “TAKEOVER IN PROGRESS.”
If the TAKEOVER is finished, RDF displays the following message in response to
the STATUS RDF command:
STATUS RDF (\SANFRAN -> \TORONTO6) is NOT running
An RDF TAKEOVER has completed
Safe MAT position is SNO 1, RBA 87876660
MAT position for File Recovery: SNO 1, RBA 87876740
Check the log for 724 or 725 messages. Message 724 indicates that the takeover
completed successfully. Message 725 indicates that it did not, and you should
reissue the TAKEOVER command.