RDF/IMP, IMPX, and ZLT System Management Manual

RDF Command Summary
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
A-6
RESET
The RESET command resets all configuration parameters for the specified process to
their default values within the RDF configuration memory table. The corresponding
parameters within the configuration file do not change, however, unless you issue an
ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
SET EXTRACTOR
The SET EXTRACTOR command sets the designated configuration parameters for the
extractor process to the supplied values within the RDF configuration memory table.
The supplied values are not applied to the RDF configuration file, however, until you
issue an ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
RESET {RDF }
{MONITOR }
{EXTRACTOR }
{RECEIVER }
{VOLUME }
{IMAGETRAIL }
{PURGER }
{RDFNET }
{NETWORK }
SET EXTRACTOR extractor-option
where extractor-option is:
{CPUS primary-CPU : backup-CPU }
{PRIORITY priority }
{PROCESS process-name }
{ATINDEX audittrail-index-number }
{RTDWARNING rtd-time }
{VOLUME volume-name }