RDF/IMP, IMPX, and ZLT System Management Manual

RDF Command Summary
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
A-11
SHOW
The SHOW command displays the current parameter values contained in the RDF
configuration memory table for the specified process. With this command, you can
confirm the parameter values before issuing the ADD command that actually applies
them to the configuration file.
Where Issued: Primary or backup system.
Security: Any user.
START RDF
The START RDF command starts the RDF subsystem.
Where Issued: Primary system only.
Security: Super-user group member, and remote passwords on both the primary and
backup systems.
START UPDATE
The START UPDATE command starts all updater processes on the backup system.
Where Issued: Primary system only.
Security: Super-user group member, and remote passwords on both the primary and
backup systems.
SHOW {RDF }
{MONITOR }
{EXTRACTOR }
{RECEIVER }
{IMAGETRAIL }
{VOLUME }
{PURGER }
{RDFNET }
{NETWORK }
START RDF [,UPDATE {ON | OFF}]
START UPDATE