RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-12
RDF Messages
726
vol => vol
are the volume on the primary node that the updater is protecting and the
corresponding volume to which it is writing on the backup node.
Cause. The purger has determined that the updater process indicated in this message
did not complete its RDF takeover processing. That updater may have stopped
prematurely because of a double CPU failure or a STOP command entered manually
from TACL.
Effect. The updater responsible for the volume named in the message did not
complete RDF takeover processing.
Recovery. When you have determined why the updater stopped prematurely and
have corrected the problem, reissue the RDFCOM TAKEOVER command.
727
sno
is the sequence number of the missing audit trail file.
Cause. The specified file should exist on disk, but it does not.
Effect. The extractor abends.
Recovery. This is an internal error. Contact your service provider.
728
Cause. The CPU of the backup process of a process pair failed.
Effect. The primary process continues to run, but not in fault-tolerant mode.
Recovery. Reload the downed processor. The backup process is re-created when the
processor is reloaded.
Updater did not complete the TAKEOVER <vol => vol>
Audit trail file missing SNO sno
Backup Processor Down