RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual524388-002
C-15
RDF Messages
programfile
is the name of the object file from where the process that sent the message was
started.
Cause. An RDF process received a message that does not apply to it.
This message is a warning that indicates a possible problem in the configuration file, a
programming problem within RDF, or that a process outside of RDF tried to
communicate with an RDF process. Whenever possible, this message includes the
offending process name or process id as well as the program file name.
Effect. The message type is reported with no other effect.
Recovery. Informational message only; no corrective action is needed. To see if the
message resulted from an incorrect configuration file, examine the configuration file
and verify that all necessary parameters have been specified correctly. Report this
error to your service provider.
735
sno
is the sequence number in the Master Audit Trail (MAT) of the last audit record
received by the RDF receiver process.
rba
is the relative byte address of the record.
Cause. The purger logs this message after successful completion of an RDF takeover
operation.
If all data volumes on the primary system are configured to the MAT, then the reported
position is the end of the last record received from the extractor.
If any data volumes on the primary system are configured to auxiliary audit trails, then
the reported position is the end of the last commit or abort record received from the
extractor for which no data from any auxiliary audit trail is missing.
Effect. The MAT position is used for two purposes:
1. to compare MAT positions in preparation for the COPYAUDIT command of the
Triple Contingency protocol
2. to use for File Recovery to a MAT position on the primary system
Recovery. Informational message only; no corrective action is needed.
MAT position of last audit record SNO sno RBA rba