RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-17
RDF Messages
rba
is the relative byte address of the synchronization point.
Cause. This message indicates that te receiver has sent the extractor a starting
position in the TMF audit trail, and the extractor has thereby become synchronized with
the receiver.
Effect. The extractor is synchronized with the receiver.
Recovery. Informational message only; no corrective action is needed.
739
error
is the file-system error number that identifies the specific error.
filename
is the name of the file that the updater tried to create.
Cause. An updater was unable to create a file on its UPDATEVOLUME disk. The
message includes both the file-system error number and the name of the file the
updater attempted to create.
Effect. Consult Table 5-3 to determine the effect of this error.
Recovery. Consult Table 5-3 to determine the appropriate recovery actions.
740
volume
is the name of the volume that could not be found among those protected by RDF.
error
is the file-system error number that identifies the specific error.
Cause. This warning message is issued when a create operation for the primary
partition of a partitioned file must map one or more of the file’s secondary partitions to a
volume that does not match any of the volumes protected by RDF on the primary node.
This message is also issued when the creation of a file with alternate keys is attempted
and the corresponding alternate key file does not match any of the volumes protected
by RDF on the primary node.
Effect. The create operation fails and is skipped.
File creation failed. Error error On filename
Create for unprotected RDF VOLUME Failed volume. Error error