RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-24
RDF Messages
Cause. An updater has encountered an audit record associated with an Enscribe
CREATE operation, an increase of MAXEXTENTS for an Enscribe file, or a
PURGEDATA operation for an Enscribe file, and the file on the primary system has
secondary partitions that are located on different systems in the network.
Effect. The updater skips this record. Note that if the record is associated with an
Enscribe CREATE operation, no partitions of the file are created on the backup
system. Therefore, if the updater subsequently encounters another audit record
associated with that file, the updater pauses its processing until that file is created.
Alternatively, if the record was associated with a PURGEDATA operation or an
increase of MAXEXTENTS, the operation is not replicated on the backup system.
Recovery. If the record was associated with an Enscribe CREATE operation, you
must manually create the file on the backup system. If the record was associated with
a PURGEDATA operation or an increase of MAXEXTENTS, you must issue a STOP
UPDATE command and then perform the operation manually on the backup system.
760
filename
is the name of an image trail file.
Cause. The purger has determined that the specified image file is no longer needed
and has purged it.
Effect. The specified file is purged.
Recovery. Informational message only; no corrective action is needed.
761
Cause. The backup process of a process pair has been stopped. This probably was
the result of an operator inadvertently issuing a STOP command from TACL.
Effect. A new backup will be created.
Recovery. Informational message only; no corrective action is needed.
762
Cause. An RDF process has determined that the existing context file belongs to an
older version of RDF.
Image trail file purged filename
Backup stopped
Context file is old; must INITIALIZE RDF