RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-30
RDF Messages
Effect. The extractor abends.
Recovery. You must initialize RDF to a new database synchronization timestamp and
then restart the entire operation from the beginning.
782
Cause. Phase two of a database synchronization operation involving the process that
generated this message is complete.
Effect. If the process is the extractor, then all operations performed by the extractor for
the database synchronization are complete, although the updaters might not have
completed their work on the backup system. If the process is an updater, then the
backup database is synchronized for the volume protected by the particular updater.
Recovery. Informational message only; no corrective action is needed.
783
Cause. The monitor or extractor process could not open the remote receiver process
after a communications failure.
Effect. If the monitor or extractor process receives a file-system error 14 (process
does not exist), RDF will shut down on the primary node.
Recovery. If RDF was stopped on the remote node by a STOP RDF command while
the communications lines were down, simply restart RDF by issuing a START RDF
command.
784
timestamp
is the specified timestamp.
Cause. The operator issued an RDFCOM STOP UPDATE, TIMESTAMP command at
the primary node.
Effect. Each updater applies only audit data associated with transactions that
committed prior to the specified timestamp.
Recovery. Informational message only; no corrective action is needed.
Phase two database synchronization complete
RDF receiver process is not running
Shutdown pending STOP UPDATE, TIMESTAMP timestamp