RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-31
RDF Messages
785
timestamp
is the timestamp specified previously by an operator in an RDFCOM STOP
UPDATE, TIMESTAMP timestamp command.
Cause. A STOP UPDATE, TIMESTAMP timestamp command has been issued and
the updater has completed its redo pass.
Effect. The updater is ready to commence its undo pass.
Recovery. Informational message only; no corrective action is needed.
786
Cause. The extractor has received notification of a STOP SYNCH command. This
event represents the start of part 1 of phase one of the extractor’s work in an online
database synchronization operation.
Effect. When the extractor encounters the next TMP control point record in the MAT, it
enters phase one, part 1 processing.
Recovery. Informational message only; no corrective action is needed.
787
error
is the error number that identifies the specific error.
filename
is the name of the image trail file that contained the error.
sno
is the sequence number where the error occurred.
rba
is the relative byte address where the error occurred.
Redo pass ending on reaching timestamp timestamp
STOP SYNCH message received
Image trail file position error error on filename. SNO sno
RBA rba