RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-32
RDF Messages
Cause. The receiver or an updater has encountered the indicated error while
attempting to position within an image file.
Effect. The process abends.
Recovery. Correct the problem that caused the error and then restart RDF.
788
status
is a status code reflecting information about the error.
Cause. An RDF process received an error from the ALLOCATESEGMENT system
procedure.
Effect. This is a catastrophic error; the process abends, and RDF stops.
Recovery. Consult the description of the ALLOCATESEGMENT procedure in the
Guardian Procedure Calls Reference Manual to determine the cause of the failure.
Once the underlying cause is corrected, you can restart RDF.
789
error
is the error number that identifies the specific error.
Cause. The primary process of an RDF process pair received an error from the
CHECKALLOCATESEGMENT system procedure.
Effect. This error is not fatal; processing continues. The backup process is stopped
and then re-created later.
Recovery. Consult the description of the CHECKALLOCATESEGMENT procedure
errors in the Guardian Procedure Errors and Messages Manual to determine the cause
of the failure. Some corrective action might be required for the backup process to be
re-created without repeated failures. The most likely cause is insufficient space
available for swapping on the swap volume.
ALLOCATESEGMENT failure. Returned status status
CHECKALLOCATESEGMENT failed with error error