RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-39
RDF Messages
Cause. The updater encountered a file-system error while attempting to communicate
with the receiver or purger. The file-system error number and the name of the receiver
or purger are included in the message.
Effect. This is a catastrophic error; the updater abends, and RDF stops.
Recovery. Determine the cause of the error. If the receiver or purger did not abend,
correct the condition, then restart RDF.
813
Cause. This message is reported by updater processes when the number of
concurrent file opens exceeds the capacity of the table in which the updater maintains
information about file opens.
Effect. The updater will close idle files (if any) and continue. If there are no idle files,
then the updater will close all files and establish a restart point from which processing
can continue. In the latter case, there will be a performance degradation.
Recovery. Informational message only; no corrective action is needed. If the
condition persists, however, your database administrator should consider moving some
of the files protected by TMF on the primary node volume to another volume, and
adding another updater to back up the new volume. If you do that, you must
synchronize the affected volumes on the primary and backup nodes.
814
cpu#
is the number of the processor in which the backup process is now running.
Cause. The primary process has stopped for some reason, perhaps a cpu failure.
Effect. The backup process of the process pair (in the designated cpu) has taken
over.
Recovery. Informational message only; no corrective action is needed. You should,
however, determine why the primary process stopped, and take corrective action if
necessary.
Concurrent file opens exceed capacity
Backup process takeover in processor cpu#