RDF/IMP, IMPX, and ZLT System Management Manual
Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-40
RDF Messages
815
cpu#
is the number of the processor in which the primary process is now running.
Cause. A new primary process has been created by the backup process, and the
backup process has switched control to that primary process.
Effect. The primary process of the process pair (in the designated cpu) has taken
over.
Recovery. Informational message only; no corrective action is needed.
816
error
is a file-system error number.
filename
is the name of the image file associated with the error.
Cause. The receiver or purger process encountered an error while attempting to
perform a setmode operation on the specified file.
Effect. The process abends.
Recovery. Correct the problem that led to the error and then restart RDF.
817
Cause. The operator issued a STOP UPDATE command, and the updater is stopping
normally. This message is issued only by updater processes.
Effect. The updater stops.
Recovery. Informational message only; no corrective action is needed.
Primary process takeover in processor cpu#
Image trail file SETMODE error error on filename
Shutting down in response to STOP UPDATE