RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-42
RDF Messages
821
updater
is the name of the updater process that stopped.
Cause. An updater has stopped unexpectedly.
Effect. This message is issued by the RDF monitor. The monitor sends an abort
request to all remaining RDF processes to stop RDF.
Recovery. A subsequent warm start of RDF will probably be successful, but the
success of the restart depends on the nature of the failure that caused the original
updater process to stop.
822
Cause. An RDF process is being shut down by the RDF monitor following the
premature loss of another RDF process.
Effect. The process stops normally.
Recovery. Scan the EMS event log to determine the original cause of the failure. It
might be possible to restart RDF.
823
%num num num num
identifies a network transaction.
Cause. This network transaction was committed in the audit trail on the primary
system after the first network transaction marked for undo. It can be kept because it
committed prior to the first network transaction marked for undo on a different node in
the RDF network. Please note, however, that this transaction could still be undone
during final checking for business consistency across all backup nodes.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
RDF updater stopped unexpectedly, updater
Shutting down in response to ABORT RDF
Network transaction to be kept: %num num num num