RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-44
RDF Messages
828
Cause. The primary process of a process pair has detected a problem in
communicating with the backup process. An earlier message will have indicated the
communications problem.
Effect. Because of the severity of the problem, the primary process attempts to stop
the backup process. If the backup process stops, the primary process then attempts to
create a new backup process.
Recovery. Informational message only; no corrective action is needed.
829
Cause. This message indicates that the monitor detected an RDF takeover operation
was executed on the RDF backup system.
Effect. This is a catastrophic error and will cause RDF to abort.
Recovery. You must reinitialize the RDF subsystem and you might need to
resynchronize your backup database with the primary database.
830
name
is the name of the RDF process that was not stopped.
Cause. The RDF monitor is attempting to stop a process on the backup node but
cannot do so because the communications lines are down.
Effect. If a STOP RDF command was being processed, the RDF monitor continues
with the shutdown, and all processes on the primary node will stop. The backup
processes will remain running.
Recovery. To stop the RDF processes on the backup node, you must run RDFCOM
on the backup node and issue a second STOP RDF command. Once all the
processes have stopped, RDF can be restarted when the network is restored.
Killing backup process ...
An RDF takeover operation was initiated on the backup system.
Warning - Network down when stopping process name