RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-46
RDF Messages
message could also mean that the audit trail file was corrupted by some program other
than TMF, or that an irrecoverable system error has occurred.
In any event, you will have to reinitialize the TMF and RDF subsystems.
Save the audit trail, and report this error to your service provider.
834
reason
is a reason code.
Cause. This message is issued by the purger process if it has to terminate the current
purge pass for one of a variety of reasons. The reason codes refer to the internal
conditions that may be of use to support and development personnel.
Effect. The purger terminates the current purge pass. A new purge pass is initiated
after PURGETIME minutes.
Recovery. Informational message only; no corrective action is needed. Under normal
conditions, this message should be logged infrequently. If the event appears regularly
and if the purger stops purging files, it could be an indication of throughput problems
between the extractor and receiver processes. If this message persists, and the
purger has stopped purging old image files, and the extractor has not fallen behind,
contact your service provider.
835
csv
specifies the RDF control subvolume of the affected RDF environment.
command-text
is the text of the command that was issued.
Cause. The operator issued one of the following commands: ALTER, INITIALIZE RDF,
START RDF, START UPDATE, STOP RDF, STOP UPDATE, or TAKEOVER.
Effect. The RDF command is executed.
Recovery. Informational message only; no corrective action is needed.
Purge pass terminated prematurely. Reason: reason
csv command-text