RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-61
RDF Messages
Recovery. Reset your RDF configurations and/or your SMF configuration so that the
updaters are either assigned to physical volumes, or your SMF virtual disks map to 15
or fewer physical volumes.
884
Cause. The RDFNET process encountered a condition that caused it to restart.
Effect. The process restarts and resumes normal processing.
Recovery. Examine preceding events for this process to try to determine why the
process is restarting. Take corrective action if necessary.
885
Cause. The updater has reached the end of local takeover processing for an RDF
network environment
Effect. The updater is ready to commence the next phase of undo processing.
Recovery. Informational message only; no corrective action is needed.
886
Cause. The updater has reached the end of network undo takeover processing for an
RDF network environment.
Effect. The updater is ready to complete takeover processing.
Recovery. Informational message only; no corrective action is needed.
887
Cause. The updater has more transactions to undo that can be undone in a single
network undo pass. Therefore it is starting an additional network undo pass.
Effect. The updater starts an additional network undo pass.
Recovery. Informational message only; no corrective action is needed.
The RDFNET process is restarting.
Updater phase one takeover processing complete.
Updater phase three takeover processing complete
Commencing an additional network undo pass