RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-62
RDF Messages
888
Cause. A successful takeover has completed. If you need to bring your primary
database back into synchronization with your backup database, use TMF File
Recovery on your primary system with the specified MAT position.
Effect. None.
Recovery. Informational message only; no corrective action is needed. Consult TMF
documentation for information about TMF File Recovery to an audit-trail position
(TOMATPOSITION).
889
Cause. The purger has been attempting to build the network undo list, but is has
either encountered a network error or it has been waiting too long for information it
needs.
Effect. The purger begins another attempt to build the list.
Recovery. Informational message only; no corrective action is needed. You should
examine the event log to see if the purger has reported a network error and take
corrective action if required. If no errors have been reported, then the purger is waiting
for another purger in the RDF network to complete work. If this is the case, you have
no recovery action. The local purger will retry until the remote purger has completed
the required work.
890
Cause. The purger is ready to try to build the network undo list. This event indicates
that this is the purger's first attempt or it is about to retry the operation because of a
previous failure.
Effect. The purger begins another attempt to build the list.
Recovery. Informational message only; no corrective action is needed.
MAT position for File Recovery: SNO <num> RBA <num>
Purger restarting on attempt to build network undo list.
Purger attempting to build network undo list.