RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-64
RDF Messages
894
sno
is the sequence number.
rba
is the relative byte address.
Cause. The auxiliary receiver has detected information about an SQL Shared Access
DDL operation associated with the specified SNO and RBA in the master audit trail on
your primary system.
Effect. The auxiliary receiver coordinates stopping its updsaters at the correct
location.
Recovery. Informational message only; no corrective action is needed. When all
updaters on all trails have shut down for the SQL NSA operation, you can execute the
same DDL operation on your backup system. After having done so, you can restart
your updaters.
895
Cause. You have performed a stop-update-to-time operation, but not all the volumes
on the RDF primary system are up and recovered.
Effect. The operation is aborted, and the RDF subsystem aborts.
Recovery. You can restart the RDF product immediately, but you cannot perform a
new stop-update-to-time operation until you have enabled all RDF protected volumes
on your primary system.
896
Cause. The updater has reached the end of file incomplete undo takeover processing
for an RDF environment.
Effect. The updater is ready to complete takeover processing.
Recovery. Informational message only; no corrective action is needed.
SQL NSA operation detected at SNO sno RBA rba
File incomplete record encountered during stop-update-to-time
operation.
Updater phase two takeover processing complete.