RDF/IMP, IMPX, and ZLT System Management Manual

Messages
HP NonStop RDF/IMP, IMPX, and ZLT System Management Manual—524388-002
C-66
RDF Messages
Recovery. Informational message only; no corrective action is needed.
901
Cause. The extractor is started on the ZLT standby system for ZLT processing.
Effect. The extractor reads and sends all remaining audit from the remote mirror(s)
connected to the ZLT standby system to the receiver on the backup system.
Recovery. Informational message only; no corrective action is needed.
902
volume
is a volume name.
Cause. The extractor has determined that the specified remote mirror is not connected
to the ZLT standby system.
Effect. The extractor abends.
Recovery. Connect all required remote mirrors to the ZLT standby system and then
reissue the RDF TAKEOVER command.
903
Cause. All remaining audit from the ZLT standby system has been received and
stored in the image trails for this receiver.
Effect. If this message comes from the master receiver, normal RDF TAKEOVER
processing is ready to proceed. If this message comes from an auxiliary receiver,
normal RDF TAKEOVER processing does not start until the master receiver has
finished ZLT processing.
Recovery. Informational message only; no corrective action is needed.
904
Cause. The master receiver has found a TMF shutdown record. The auxiliary receiver
reporting this event is working to catch up to the corresponding point.
Extractor is started for ZLT processing
The remote mirror for volume is missing
Receiver has finished ZLT processing
Auxiliary receiver is catching up