RSC/MP 7.3 Installation and Configuration Guide

HP NonStop Remote Server Call (RSC/MP) Installation and Configuration Guide—522358-011

14-1

Configuring the RSC/MP Client

This section describes how to configure the client workstations.

RSC/MP Client Configuration and Verification

Follow these steps to configure and test the RSC/MP client:

1. Install and configure the host component (see Section 3, Installing RSC/MP on the

Host, and Section 12, Configuring and Managing the RSC/MP TDP Process).

2. Install the RSC/MP client software (see Section 4, Installing RSC/MP on Windows

Workstations, or Section 6, Installing RSC/MP on UNIX Workstations).

3. Configure the RSC/MP transport (see Section 5, Configuring the RSC/MP

Transport (Piccolo)).

4. Configure the RSC.INI (see Basic RSC.INI Configuration on page 14-2).

5. Start the RSC/MP transport manager (see Starting the RSC/MP Transport

Manager (Pipeman) on page 14-4).

6. Test the RSC/MP installation and configuration (see Testing the RSC/MP Client

Configuration on page 14-8).

Prerequisites to Configuring RSC/MP

Before configuring RSC/MP perform the following steps:

1. Read the softdoc shipped with this release.

2. Install the RSC/MP client software on the target workstation.

3. Ensure that the network communications facility (for example, TCP/IP network or

asynchronous communications line) is installed, connected, configured, and

working properly.

4. Gather the following information:

•

System name of destination host system

•

TDP TERM object name

•

TDP PIPE object name