RSC/MP 7.3 Installation and Configuration Guide

HP NonStop Remote Server Call (RSC/MP) Installation and Configuration Guide—522358-011
3-1
3
Installing RSC/MP on the Host
The main component of the RSC/MP NonStop host software is the Transaction
Delivery Process (TDP) that manages transactions between the NonStop host and
client workstations. The files that are installed on the host are listed in Files Installed on
the RSC/MP Host on page 3-2. For new installations or upgrades, install the host
software first and then the workstation software.
To install RSC/MP on a NonStop host, do the following:
•
Make sure you are running the minimum software and hardware requirements.
Refer to the README.TXT file on the RSC/MP CD.
•
Perform the installation according to the instructions provided with the CD.
•
Verify that the correct files have been installed.
•
Configure and start the RSC/MP host (see Section 12, Configuring and Managing
the RSC/MP TDP Process).
Installation from the CD
Follow these steps to install the software from the CD:
1. Follow the directions in the README.TXT file on the RSC/MP CD to copy the
RSC/MP host software archive from the CD to the host via a PC.
2. Follow the directions in the IPSetup User’s Guide (USRGUIDE.PDF) on the CD,
under the INSTALL directory, to transfer the archive files from the PC to the host.
Refer to the “Manual Software Placement Using the IPSetup TACL Program”
section.
3. Log onto the host as SUPER.SUPER and run SETUPRUN to expand the archive
file to a distributed subvolume (DSV) by following the instructions in section
“Manual Software Placement Using the IPSetup TACL Program”.
4. If you manage your software configuration using DSM/SCM (distributed system
management/system configuration management), use DSM/SCM to transfer the
DSVs to the proper install subvolumes ISVs. Non-DSM/SCM users will need to
manually rename the DSVs to the necessary ISVs. Refer to the README.TXT file
for the proper ISV names.
5. (Optional.) Perform a receive software and build/apply using DSM/SCM to save the
software in the DSM/SCM archives and move it to the NonStop ISV (installation
subvolume).
6. (Optional.) After completing the DSM/SCM build/apply the files in the NonStop ISV
will be installed as shown in Files Installed on the RSC/MP Host on page 3-2.
7. Set the volume to the NonStop ISV (ZRSCHOST).