RSC/MP 7.3 Installation and Configuration Guide

Installing RSC/MP on Windows Workstations
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration Guide—522358-011
4-11
Using RSC/MP from Another Service (Win32+TSE
Client Only)
To change the startup mode on Windows NT:
1. Open the Control Panel.
2. From the Control Panel, open Services.
3. Select RSC from the Services list.
4. Click on the Startup button.
5. Select either Automatic, Manual, or Disabled in the Service dialog.
6. Close the dialog box.
7. Select Piccolo from the Services list.
8. Click on the Startup button.
9. Select either Automatic, Manual, or Disabled in the Service dialog.
10. Close the dialog box.
To change the startup mode on Windows 2000 or Windows XP:
1. Open the Control Panel.
2. Open Administrative Tools folder, then open Computer Management.
3. Open the Services and Applications group and select Services.
4. Double-click on RSC to open the RSC Properties sheet.
5. Choose the General tab and adjust the Startup type to Automatic, Manual, or
Disabled.
6. Close the RSC Properties sheet.
7. Double-click on Piccolo to open the Piccolo Properties sheet.
8. Choose the General tab and adjust the Startup type to Automatic, Manual, or
Disabled.
9. Close the Piccolo Properties sheet.
Using RSC/MP from Another Service (Win32+TSE Client Only)
The internal name for the RSC Service is RemoteServerCall. If you write a service that
depends upon RSC/MP, your service should register its dependency on
RemoteServerCall with the Service Control Manager. Because the RSC Service itself
is already dependent upon the Piccolo Service, your service does not need to explicitly
register its dependency upon Piccolo.
Note.
The “Interact with Desktop” setting must be set to “YES” in order for the Win32 client to
function properly. This restriction does not apply to the Win32+TSE client.