RSC/MP 7.3 Installation and Configuration Guide

Asynchronous Network Interface Configuration
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration Guide—522358-011
7-2
Asynchronous Network Interface Addressing
See Configuration Options Reference on page 7-2 for more information about the
asynchronous network options that are used in the NIF-nifname section in the PIPE.INI
file.
Asynchronous Network Interface Addressing
You can use the Resolver section to map system addresses to network addresses.
The asynchronous network interface allows each tag to be specified only once. If the
extended address contains an explicit comdevice parameter, it must be the same
device that is configured for the asynchronous ComDevice option.
Sample asynchronous resolver entries for this interface are:
asy1.corsof.com=$phone:[phone]
asy2.corsof.com=comdevice:*,$phone:[phone]
asy3.corsof.com=comoptions:*,$phone:[phone]
asy4.corsof.com=comdevice:com2,$phone:[phone]
Configuration Options Reference
The following options are available for configuring the asynchronous network interface
process in the PIPE.INI file. The example configuration file shown later in this section
uses some of these options.
Network Interface Section ([NIF-nifname])
This NIF section contains options that control the operation of the asynchronous
network. These settings are read by the NIF process when it starts. The settings in this
section are preceded by the section name [NIF-nifname], where nifname is the user-
defined symbolic name of the NIF.