RSC/MP for Microsoft Windows Vista Readme

Readme.txt
READ THIS FILE COMPLETELY BEFORE BEGINNING PRODUCT INSTALLATION
Copyright 2007 HP
Product Name: NonStop(TM) RSC/MP for Microsoft Windows Vista(TM) client
Product ID: SM76V1/HSM76V1
Component Products:
T0810V72 RSC/MP for Microsoft Windows Vista client
CD folder WS_SW contains related RPSETUP.MSI file
I. Basic Product Installation Instructions
1. Ensure that requirements for using this product are met
(see Section IV Product Requirements below).
2. Ensure that prerequisites for the installation utility and any
product-specific installation requirements are met
(see Section V Installation Prerequisites below).
3. Follow the pre-installation instructions in Section II below,
if any, before continuing.
4. Follow the post-installation instructions in section III
below, if any, after using IPSetup to place and install this
product.
* This product does not use DSM/SCM.
1. Navigate to the WS_SW folder on the RSC/MP MS Windows Vista CD.
2. Select one of the installation methods listed below:
a. Install directly onto the workstation attached to the CD
Drive by double clicking on the RPSETUP.MSI file.
b. Install on multiple workstations by copying the RPSETUP.MSI
file to a central workstation that can be accessed by all
workstations. Log on to each workstation, locate the
RPSETUP.MSI file on the central workstation and either double
click on the RPSETUP.MSI file, at a DOS prompt type
RPSETUP.MSI or select Start->Run and enter the full path of
the RPSETUP.MSI file.
c. Transfer the RPSETUP.MSI file to the NonStop and then
transfer RPSETUP.MSI to the target workstation. The file must
be transferred in BINARY mode. Log on to the workstation, locate
the RPSETUP.MSI file and either double click on the
RPSETUP.MSI file, at a DOS prompt type RPSETUP.MSI or select
Start->Run and enter the full path of the RPSETUP.MSI file.
II. Pre-Installation Instructions
1. Refer to the HP NonStop Remote Server Call (RSC/MP) Installation
and Configuration Guide.
Page 1