RSC/MP Installation and Configuration Guide

RSCCOM Command Reference STATS Command
STATS Command
The STATS command shows data accumulated wi thin the TDP of the specified
object, if the object is in the started state.
Note. Use of the STATS command with the ACS object displays the message ―STATS data is
not available for an ACS object‖.
STATS type name [ RESET ]
STATS type * [ RESET ]
type
The type of TDP object.
name
The name supplied for the object. The ACS and PIPE object name can be from 1
through 15 alphanumeric characters; the TERM object name can be from 1
through 8 characters. The name must start with a letter and is not case-sensitive.
RESET
Resets the accumulators and restarts the collection of statistical data. If the reset
occurs while a connection is being established, the Connect counter is set to 1
instead of 0.
*
Reports statistics for objects of this type.
Example:
The following command displays statistics for the TERM object named RSCQA15:
4(( STATS TERM RSCQA15
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration G uide — 52235 8- 013
11- 20