RSC/MP Installation and Configuration Guide

12 Configuring the RSC/MP Client
This section describes how to configure the client workstations.
RSC/MP Client Configuration and Verification
Follow these steps to configure and test the RSC/MP client:
1. Install and configure the host component (see Section 3, Installing RSC/MP on the
Host, and Section 10, Configuring and Managing the RSC/MP TDP Process).
2. Install the RSC/MP client software (see Section 4, Installing RSC/MP on Windows
Workstations, or Section 6, Installing RSC/MP on UNIX Workstations).
3. Configure the RSC/MP transport (see Section 5, Configuring the RSC/MP
Transport (Piccolo).
4. Configure the RSC.INI (see Basic RSC.INI Configuration on page 12-2).
5. Start the RSC/MP transport manager (see Starting the RSC/MP Transport
Manager (Pipeman) on page 12-4).
6. Test the RSC/MP installation and configuration (see Testing the RSC/MP Client
Configuration on page 12-8).
Prerequisites to Configuring RSC/MP
Before configuring RSC/MP perform the following steps:
1. Read the softdoc shipped with this release.
2. Install the RSC/MP client software on the target workstation.
3. Ensure that the network communications facility (for example, TCP/IP network)
is installed, connected, configured, and working properly.
4. Gather the following information:
System name of destination host system
TDP TERM object name
TDP PIPE object name
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration G uide — 52235 8- 013
12-1