RSC/MP Installation and Configuration Guide

Introduction Testing RSC/MP
Testing RSC/MP
Before testing RSC/MP, you must determine that the workstation is correctly connected
to the NonStop host. The method of testing connectivity depends on the type of
physical connection and protocol used; for example, use a PING command for TCP/IP
networks.
After you install and start RSC/MP, use an RSC/MP test program (RSCTESTW for
Windows, or RSCTEST for UNIX) to check the installation. This application program
sends messages of a specified length to the NonStop host. An echo server, TDDSVR,
on the host returns the messages. The RSC/MP Windows clients also provide a simple
connection test program, RSCPINGW. This test program will not attempt to contact any
server, it will simply attempt a connection.
Note. The RSC/MP test programs are not appropriate for benchmarking.
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration G uide — 52235 8- 013
1 -6