RSC/MP Installation and Configuration Guide

2 RSC/MP Quick Start Guide
This section describes how to set up an RSC/MP host on a NonStop system and an
RSC/MP Win32 client on a workstation. The Quick Start Guide describes a very basic
configuration, which may be too simplistic for your requirements. If the configuration
described here does not work, check the TroubleShooting section Appendix B,
Installation Troubleshooting for information about analyzing problems, and refer to the
rest of the manual for more detailed setup instructions.
The procedures outlined in this section assume:
The connection between the host and client workstation uses a TCP/IP protocol
The network is configured with Domain Name Services (DNS) name-resolution
The RSC/MP Session type is Interprocess (not IDS).
RSC/MP Host Installation and Configuration
These are the procedures for installing and configuring RSC/MP on a NonStop system.
For new installations or upgrades, install the host software first, followed by the
workstation software.
Installing RSC/MP on the Host
To install the RSC/MP host component:
1. Follow the directions in the README.TXT file on the RSC/MP CD to copy the
RSC/MP host software archive from the CD to the host via a PC.
2. Follow the directions in the IPSetup User’s Guide (USRGUIDE.PDF) on the CD
(under the INSTALL directory) to transfer the archive files from the PC to the host.
3. Log onto the host as SUPER.SUPER and run SETUPRUN to expand the archive
file to a distributed subvolume (DSV).
4. If you manage your software configuration using DSM/SCM (distributed system
management/system configuration management), use DSM/SCM to transfer the
DSVs to the proper install subvolumes ISVs. Non-DSM/SCM users must manually
rename the DSVs to the necessary ISVs. Refer to the README.TXT file for the
proper ISV names.
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration G uide — 52235 8- 013
2 -1