RSC/MP Installation and Configuration Guide

RSC/MP Quick Start Guide Configuring RSC/MP on the Host
Identifier
Comments
IN
(Optional, but recommended to allow Piccolo to work properly if you
exit from the terminal used to start Piccolo.) Enter an input file name.
Refer to IN Option on page 5-22 for details.
OUT
(Optional, but recommended to allow Piccolo to work properly if you
exit from the terminal used to start Piccolo.) Enter an output file name.
Refer to OUT Option on page 5-29 for details.
Term
(Optional, but recommended to allow Piccolo to work properly if you
exit from the terminal used to start Piccolo.) Enter a home terminal
name.
Refer to Te rm Option on page 5-35 for details.
NifList
Set this entry to nifsock, which matches an entry later in the file.
Refer to NifList Option on page 5-28 for details.
[NIF-nifsock]
Locate the [NIF-nifsock] identifier in the file.
Refer to Network Interface Section ([NIF-nifname]) on page 8-3 for
details.
ProgramFile
Leave ProgramFile set to nifsock, which is the executable for the
TCP/IP network interface.
Refer to ProgramFile Option on page 8-9 for details.
ServicePort
If you are using the default Piccolo ServicePort of 2787, put a
semicolon (;) in front of the line starting with ServicePort. Enter a
ServicePort if you are using a port other than the default. See your
System Adminstrator if you are not sure which port to use.
Refer to ServicePort Option on page 8-11 for details.
ProcessName
(Optional) If your TCP/IP process name is not the default $ZTCO,
enter the process name here.
Refer to ProcessName Option on page 8-9 for details.
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration G uide — 52235 8- 013
2 -3