RSC/MP Installation and Configuration Guide

Configuring the RSC/MP Transport (Piccolo) Pipeman Section ([PIPEMAN])
AutoStartTimeout Option
The AutoStartTimeout option works with the AutoStart option. When AutoStart is
enabled (set to 1), AutoStartTimeout gives the number of seconds to allow for startup
of the PIPEMAN process. The default value should be suitable for most installations.
On slow or heavily loaded systems where PIPEMAN takes a long time to start, this
setting can be increased to prevent RSC/MP from reporting Piccolo error 12
(PIPERC_PIPEMAN_NOT_RUNNING) falsely when Piccolo is being started
automatically.
AutoStartTimeout=number
number
The number of seconds to allow for startup of the PIPEMAN process.
Required: No.
Default: 10
Platforms: All
Example:
AutoStartTimeout=30
BackupCPU Option
The BackupCPU option specifies the CPU on which the Pipeman backup process
should be started at Piccolo start-up. If this option is no t specified, no backup process
is started. If the option is not valid (number out of range, CPUs listed not started, or
CPUs listed not available), a critical log message is displayed and Pipeman will not
start.
BackupCPU=number,number,number ...
number
An integer from 0 throug h 15, which is the number of an installed and runni ng
CPU. If the first CPU in the list is down, the next CPU in the list will be tried.
Required: No.
Default: None.
Platforms: NonStop
Example:
BackupCPU=1,2,3
HP NonStop Remote Server Call (RSC/MP) Installation and Configuration G uide — 52235 8- 013
5 -2 0