RSC/MP Messages Manual

Messages Reported From the Host
3045
*** Error 3045: You must supply a valid attribute type.
Cause. An object SET or ALTER command was issued without an attribute argument.
Effect. The command is rejected.
Recovery. See the Remote Server Call (RSC/MP) Installation and Configuration
Guide for the correct command syntax and reissue the command if appropriate.
3046
*** Error 3046: Attribute <name> is not valid for this object
type.
Cause. An object SET or ALTER command was issued with an attribute that is not
va lid for the specified object.
Effect. The command is rejected.
Recovery. See the Remote Server Call (RSC/MP) Installation and Configuration
Guide for a list of va lid attributes for each object and reissue the command if
appropriate.
3047
*** Warning 3047: TERM <term name> is configured as a
template. Its object state cannot be altered.
Cause. A START, STOP, or ABORT command was issued on a TERM object that is
configured as a template.
Effect. The command is rejected.
Recovery. This message is informational only. No corrective action is necessary.
3049
*** Error 3049: <attribute name> is limited to <count>
characters.
Cause. The specified attribute name is too long.
Effect. The command fails.
Recovery. Reissue the command with a va lid attribute name.
HP NonStop Remote Server Call (RSC/MP) Messages Manual — 522359-006
2- 34