Safeguard Administrator's Manual (G06.29+, H06.08+, J06.03+)

Configuration
Safeguard Administrator’s Manual—523317-029
9-36
Configuring Exclusive Access at Safeguard
Terminals
Configuring Exclusive Access at Safeguard
Terminals
You can set the TERMINAL-EXCLUSIVE-ACCESS attribute so that a user who is
logged on at a Safeguard terminal has exclusive access to the terminal. This attribute
applies only to terminals that are controlled by the Safeguard software.
TERMINAL-EXCLUSIVE-ACCESS
ON specifies that access at a Safeguard terminal is exclusively reserved for the
user who is currently logged on. No other user can open the terminal during the
authenticated user session. OFF specifies that exclusive access is not guaranteed
to a user who is logged on at a Safeguard terminal. The initial value is OFF.
Configuring Warning Mode
You can configure warning mode, which allows you to test the effectiveness of your
access control lists, as described in Section 8, Warning Mode.
These attributes relate to warning mode:
SYSTEM-WARNING-MODE
ON specifies that warning mode is to be enabled. OFF specifies that warning mode
is to be disabled. The initial value is OFF.
OBJECT-WARNING-MODE
ON specifies that warning mode is to be enabled. OFF specifies that warning mode
is to be disabled. The initial value is OFF.
WARNING-FALLBACK-SECURITY
GUARDIAN specifies that warning mode is to be run with the Guardian fallback
option enabled. GRANT specifies that warning mode is to be run with the Guardian
fallback option disabled. The initial value is GUARDIAN.
To change any of these values, issue the ALTER SAFEGUARD command from
SAFECOM. For example, to enable warning mode and to disable the Guardian fallback
option:
=ALTER SAFE, WARNING-MODE ON, WARNING-FALLBACK-SECURITY GRANT