Safeguard Audit Service Manual (G06.24+, H06.03+)

SAFEART Error Messages
Safeguard Audit Service Manual—520480-014
8-2
Cause. You specified a file that is not an audit file in an AUDIT FILE command.
Effect. The AUDIT FILE command is not executed.
Recovery. Reenter the command specifying an audit file name known to the system.
Cause. You used the before prefix for a primary record. This prefix is allowed only for
secondary records.
Effect. The SET WHERE command is not executed.
Recovery. Reenter the SET WHERE command without the prefix or use the prefix
only for a secondary record item.
Cause. The command line contains too many items.
Effect. The command is not executed.
Recovery. Reenter the command in separate lines.
Cause. A SAFEART command was longer than 1024 characters.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. Shorten the command or break it into two commands before reentering it.
Cause. The file defined in a LOG command could not be opened.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. If the disk file did not exist before running SAFEART, check the spelling of
the volume and subvolume names if you specified them. If the disk file already exists,
check the spelling of the volume, subvolume, and file names and check that the file
has write access. If the file refers to a device name, check the spelling of the name and
the availability of the device.
ERROR: Audit file specified must have a file code of 541.
ERROR: Before prefix not allowed for item item-name.
ERROR: Command line too complex.
ERROR: Command too long.
ERROR: Could not open LOG file.