Safeguard Audit Service Manual (G06.24+, H06.03+)

SAFEART Error Messages
Safeguard Audit Service Manual—520480-014
8-3
Cause. The command file could not be opened.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. Check the spelling of the command file name. If the name is correct, check
that the file exists in the volume and subvolume you specified or in the default volume
and subvolume if you provided only a file name.
Cause. The file defined in an OUT command could not be opened.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. If the disk file did not exist before running SAFEART, check the spelling of
the volume and subvolume names if you specified them. If the disk file already exists,
check the spelling of the volume, subvolume, and file names and check that the file
has write-access. If the file refers to a device name, check the spelling of the name and
the availability of the device.
Cause. The report defined in a SET DESTINATION FILE command could not be
opened.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. If the disk file did not exist before running SAFEART, check the spelling of
the volume, subvolume, and file name. If the disk file already exists, check the spelling
of the volume, subvolume, and file names and check that the file has write access. If
the file refers to a device name, check the spelling of the name and the availability of
the device.
Cause. An audit file of an earlier product version with incompatible data structures
was specified.
Effect. Processing ends, and you are returned to the command interpreter prompt
rather than the SAFEART prompt.
Recovery. Specify a current-version audit file.
ERROR: Could not open obey file.
ERROR: Could not open OUT file.
ERROR: Could not open report file.
ERROR: Incompatible audit file was detected.