Safeguard Audit Service Manual (G06.24+, H06.03+)

SAFEART Error Messages
Safeguard Audit Service Manual—520480-014
8-5
Cause. You used a number that contains characters other than the digits 0 through 9.
Effect. The command is not executed.
Recovery. Reenter the command using a valid number.
Cause. You used an invalid operator for a record item in a comparison statement for a
SET WHERE command.
Effect. The SET WHERE command is not executed.
Recovery. Reenter the SET WHERE expression using a valid operator.
Cause. You entered a command with a character that cannot be displayed or printed.
For example, possibly you pressed the Ctrl or Alt key with a printable character.
Effect. The command is not executed.
Recovery. Reenter the command using only printable ASCII characters.
Cause. The page size in a SET PAGE SIZE command was out of range.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. Reenter the command with a page size value in the range 9 through
10,000.
Cause. The page size is less than the number of titles.
Effect. The command is not executed.
Recovery. Increase the page size or specify fewer titles.
ERROR: Numbers must contain only digits.
ERROR: Only operators '=' and '<>' allowed for item item-name.
ERROR: Only printable characters can be used in commands.
ERROR: Page size must be between 9 and 10000.
ERROR: Page size must be greater than the number of titles.